Wiki
  • About CBUnmanned
  • Products
    • CBUnmanned Stamp Eco System
      • Start Here & FAQs
      • H743 Stamp Flight Controller (& Low Cost)
        • Pin Out
        • ArduPilot Wiring & Parameters
        • PCB Footprints & 3D Model
        • Breakout PCB Pinout
        • Flashing & Firmware
      • AM32 ESC
        • PCB Footprints
        • Example PCB Schematics & Layouts
        • Firmware
      • CAN Stamp
        • Example Schematics and Firmware
    • OpenWRT UAV Router
      • Getting Started
      • Connections & Pinout
      • Update Firmware
      • USB Data Tethering
      • TailScale VPN
      • Mavlink Through Serial
      • Mavlink Through Ethernet
      • Mavlink Forwarding with mavp2p
    • 2-8s Battery Monitor
  • Products (EOL)
    • CBU-CM405-FC (EOL)
      • Overview & Initial Setup
      • Female Header F405
        • RC In/SBus Wiring
        • UART
        • I2C
      • Male Header USB Hub
      • Micro USB
      • ESC Connector
        • CM405-FC-BO Pinout
      • Cameras
      • Micro SD Card
      • 40 Pin GPIO
      • FC>CM4 Telemetry
      • DIP Switch
      • Flashing Guide
        • STM32F405
        • Compute Module 4 EMMC
      • Firmware Build Files
        • CM4
        • ArduPilot
          • hwdef.dat
          • hwdef-bl.dat
      • Power Requirements
      • 3D Printable Frames
Powered by GitBook
On this page
  1. Products (EOL)
  2. CBU-CM405-FC (EOL)
  3. Female Header F405

RC In/SBus Wiring

PreviousFemale Header F405NextUART

Last updated 2 years ago

To Enable SBus input, use a male>male jumper to connect the top pins together, and then connect RC SBus to "Sbus" Pin. UART 5 is reserved for SBus.

To use TBS Crossfire style RC Link (using a Normal UART) ensure SBus jumper is NOT fitted and use the 5v, Gnd, R5, T5 pins.