Wiki
  • About CBUnmanned
  • Products
    • CBUnmanned Stamp Eco System
      • Start Here & FAQs
      • H743 Stamp Flight Controller (& Low Cost)
        • Pin Out
        • ArduPilot Wiring & Parameters
        • PCB Footprints & 3D Model
        • Breakout PCB Pinout
        • Flashing & Firmware
      • AM32 ESC
        • PCB Footprints
        • Example PCB Schematics & Layouts
        • Firmware
      • CAN Stamp
        • Example Schematics and Firmware
    • OpenWRT UAV Router
      • Getting Started
      • Connections & Pinout
      • Update Firmware
      • USB Data Tethering
      • TailScale VPN
      • Mavlink Through Serial
      • Mavlink Through Ethernet
      • Mavlink Forwarding with mavp2p
    • 2-8s Battery Monitor
  • Products (EOL)
    • CBU-CM405-FC (EOL)
      • Overview & Initial Setup
      • Female Header F405
        • RC In/SBus Wiring
        • UART
        • I2C
      • Male Header USB Hub
      • Micro USB
      • ESC Connector
        • CM405-FC-BO Pinout
      • Cameras
      • Micro SD Card
      • 40 Pin GPIO
      • FC>CM4 Telemetry
      • DIP Switch
      • Flashing Guide
        • STM32F405
        • Compute Module 4 EMMC
      • Firmware Build Files
        • CM4
        • ArduPilot
          • hwdef.dat
          • hwdef-bl.dat
      • Power Requirements
      • 3D Printable Frames
Powered by GitBook
On this page
  1. Products (EOL)
  2. CBU-CM405-FC (EOL)

Male Header USB Hub

PreviousI2CNextMicro USB

Last updated 2 years ago

The CM4 is connected through a USB MUX to a 4 port USB Host Hub. The connections are broken out with male pin headers and are designed to be used with most PC Motherboard USB 2.0 breakouts. Power is provided directly form the onboard regulator (5v@3amps).

USB 1 - Red

USB 2 - Blue

USB 3 - Purple

USB 4 - Brown

The USB Mux auto selects between connecting the CM4 to the USB Hub (DIP (1) in OFF position) and the Micro USB for EMMC Flashing (DIP (1) in ON position).